Step 9. Final Installation Checklist - Samsung NX58J7750SS Installation Manual

Installation instructions
Checking the flame quality:
All combustion flames need to be visually checked to determine their flame quality.

Step 9. Final installation checklist

You have just completed installing your range. Make sure all controls are in the off position
and the flow of ventilation air to the range is unobstructed. The following is a checklist to
confirm your range is safely installed and ready for operation.
Locking screw
34 English
(Install)NX58J7750SS_DG68-00624A-00_EN.indd 34
1
2
3
Gas Range Plug
1. Soft blue flames—Normal for natural gas
operation.
2. Yellow tips on outer cones—Normal for LP
gas operation.
3. Yellow flames—Abnormal for any gas
operation; call for service.
NOTE
If burner flame looks like 3, the range
should not be used until it is serviced. Call
for service. Normal burner flames shall look
like 1 or 2, depending on the gas type you
use.
- Gas line has been properly connected to
the range. The gas has been turned on. All
connections have been checked for leaks.
- Range is plugged into the properly
grounded electrical receptacle.
- Approved anti-tip bracket is properly
installed and engaged with the range.
- Range is leveled and is firmly sitting on a
solid, level floor.
- Gas surface burners have been properly
assembled.
- All burners have been tested for proper
operation.
- FOR INSTALLER ONLY—Check and/or
adjust the broil and oven burner flames as
described on page 35-36 in this manual.
2015-02-04 11:52:44