Adjusting The Oven Burner Air Adjustment Shutters - Samsung NX58J7750SS Installation Manual

Adjusting the oven burner air adjustment shutters

To check and adjust the oven burner air adjustment shutters:
1. Open the oven door.
2. Remove the oven racks.
3. Remove the oven floor.
4. Press the Bake pad, then the START pad.
Locking screw
(Install)NX58J7750SS_DG68-00624A-00_EN.indd 35
All oven burners have an air adjustment
shutter. The purpose of the shutter is to
Air
regulate the flow of air to the flames.
adjustment
Properly adjusted flames should burn
shutter
steadily with approximately 1-in of blue
cone. The flames should never extend
past the edge of the burner baffles. Even
though these are preset at the factory, they
should be checked and, if needed, adjusted
periodically to ensure efficient operation.
5. After the oven has lit, visually check the
The shutters are located at the base of the
burner manifolds near the back oven wall.
To adjust the shutter, loosen the locking
screw and rotate the shutter towards the
open or closed position as needed. If flames
are lifting off the burner ports, gradually
reduce the air shutter opening until the
flames are stabilized.
If flames are too yellow and/or too large,
gradually increase the air shutter opening
until the flames have approximately a 1-in
blue cone.
If the range is set up for natural gas, the
flames should burn with no yellow tipping.
If the range is set up for LP gas, small
yellow tips at the end of the cones are
normal.
flames coming out of the upper and lower
burners. If adjustment is needed, carefully
adjust the air adjustment shutters.
NOTE
English 35
2015-02-04 11:52:44