Step 4. Install The Anti-Tip Device - Samsung NX58J7750SS Installation Manual

Installation instructions

Step 4. Install the anti-tip device

WARNING
To reduce the risk of tipping, the appliance
must be secured by properly installing the
anti-tip device packed with the appliance.
*approximately
21/32" (16.5 mm)
To check if the bracket is installed and
engaged properly, remove storage drawer
and look underneath the range to see that
the leveling leg is engaged in the bracket.
Carefully tip the range forward. The bracket
should stop the range within 4 inches (10.2
cm) of tipping. If it does not, the bracket
must be reinstalled.
28 English
(Install)NX58J7750SS_DG68-00624A-00_EN.indd 28
Anti-Tip
bracket
Screw must enter
wood or concrete
• All ranges can tip, resulting in personal
injury.
• Tipping ranges can cause burns from spills,
personal injury, and/or death.
• To prevent accidental tipping, install and
check the anti-tip bracket following the
instructions and template supplied with
the bracket.
An anti-tip bracket and screws, installation
instructions, and template are shipped
with every range (PN DG94-00870B). The
instructions include information necessary
to complete the installation of the anti-tip
bracket. Read and follow the instructions on
the sheet and use the template for anti-tip
bracket installation. If not properly installed,
the range could be tipped by you or a child
standing, sitting, or leaning on an open oven
door.
*NOTE: To install
the Anti-Tip bracket,
release the leveling leg.
A minimum clearance
of 21/32" (16.5 mm) is
required between the
range bottom and the
kitchen floor.
If the range is pulled from the wall for any
reason, always repeat this procedure to
verify the range is properly secured by the
anti-tip bracket. Never completely remove
the leveling legs or the range will not be
secured to the anti-tip device properly.
2015-02-04 11:52:40