Asus B150M-C User Manual page 22

Audio 2.1, 4.1, 5.1, or 7.1-channel configuration
Port
Light Blue (Rear panel)
Lime (Rear panel)
Pink (Rear panel)
Lime (Front panel)
To configure an 7.1-channel audio output:
8. USB 2.0 ports. These 4-pin Universal Serial Bus (USB) ports are for USB 2.0/1.1
devices.
9. USB 3.0 ports. These 9-pin Universal Serial Bus (USB) ports are for USB 3.0 devices.
•
•
•
10. DVI-D port. This port is for any DVI-D compatible device. DVI-D can't be converted to
output RGB Signal to CRT and isn't compatible with DVI-I.
•
•
11. HDMI port. This port is for a High-Definition Multimedia Interface (HDMI) connector,
and is HDCP compliant allowing playback of HD DVD, Blu-ray, and other protected
content.
12. PS/2 keyboard port (purple). This port is for a PS/2 keyboard.
1-14
Headset
2.1-channel
Line In Rear Speaker Out
Line Out Front Speaker Out
Mic In
-
Use a chassis with HD audio module in the front panel to support an 7.1-channel audio
output.
USB 3.0 devices can only be used for data storage.
We strongly recommend that you connect USB 3.0 devices to USB 3.0 ports for faster
and better performance from your USB 3.0 devices.
Due to the design of the Intel
USB 2.0 and USB 3.0 ports are controlled by the xHCI controller. Some legacy USB
devices must update their firmware for better compatibility.
Multi-VGA output supports up to three displays under Windows
displays under BIOS, and one display under DOS.
Intel display architecture design supports the following maximum supported pixel
®
clocks (Pixel Clock = H total x V Total x Frame Rate (Screen refresh rate)):
- DVI port: 165 MHz
- VGA port: 180 MHz
- HDMI port: 300 MHz
4.1-channel 5.1-channel
Rear Speaker Out
Front Speaker Out
Mic In Bass/Center
-
100 series chipset, all USB devices connected to the
®
Chapter 1: Product introduction
7.1-channel
Rear Speaker Out
Front Speaker Out
Bass/Center
- Side Speaker Out
OS environment, two
®