Table of Contents
Advertisement
2.
Chassis intrusion header (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor or switch. Connect
one end of the chassis intrusion sensor or switch cable to this connector. The chassis
intrusion sensor or switch sends a high-level signal to this connector when a chassis
component is removed or replaced. The signal is then generated as a chassis intrusion
event.
By default, the pin labeled "Chassis Signal" and "Ground" are shorted with a jumper
cap. Remove the jumper caps only when you intend to use the chassis intrusion
detection feature.
CHASSIS
B150M-C
B150M-C Chassis intrusion connector
1-12
Chapter 1: Product introduction
Hide quick links:
Advertisement
Table of Contents
