Figure 50
1. Brake uid reservoir
Adjusting the Parking Brake
Check the parking brake adjustment every 200
hours.
1. Pry the rubber cover off of the parking brake.
2. Loosen the set screw securing the knob to the
parking brake lever (Figure 51).
Figure 51
1. Parking brake lever
2. Knob
3. Rotate the knob until a force of 30-35 lb
(133-156 N) is required to actuate the lever.
4. Tighten the set screw and install the rubber
cover.
Belt Maintenance
Servicing the Drive Belt
Checking the Drive Belt
Check the condition and tension of the drive
belt after the first day of operation and every
200 operating hours thereafter.
2. Minimum line
3. Set screw
1. Park the machine on a level surface, shift into
Neutral, set the parking brake, turn the ignition
off, and remove the key.
2. Raise the bed and secure it with the prop rod.
3. Rotate and inspect the belt (Figure 52) for
excessive wear or damage. Replace the belt if
necessary.
Figure 52
1. Drive belt
2. Primary clutch
Replacing the Drive Belt
1. Rotate and route the belt over the secondary
clutch (Figure 52).
2. Remove the belt from the primary clutch
(Figure 52).
3. To replace the belt, reverse the procedure.
Cleaning
Washing the Vehicle
The vehicle should be washed as needed. Use
water alone or with a mild detergent. A rag may
be used, however the hood will loose some of its
luster.
Important: Pressurized water is not
recommended when washing the machine.
It may damage the electrical system, loosen
important decals, or wash away necessary
grease at friction points. Avoid excessive use
of water, especially near the control panel,
engine, and battery.
39
3. Secondary clutch