3. Remove the clamps securing the fuel filter to
the fuel lines (Figure 37), as follows:
A. Squeeze the clamp tabs together and slide
the clamps up the hose off of the filter
hose fittings.
B. Pull the hose ends off of the filter hose
fittings.
Figure 37
1. Fuel lter
4. Install the replacement filter to the fuel lines
with the clamps previously removed.
Mount the filter so that the arrow points
toward the carburetor.
Electrical System
Maintenance
Replacing the Fuses
There are 3 fuses in the electrical system. They are
located beneath the bed in a box on the right hand
side of the frame (Figure 38).
Charge circuit
Lights
Power Point
Low oil light and hour
meter
25 amp.
10 amp.
10 amp. (15 amp. max.)
10 amp.
32
Figure 38
1. Charge circuit
2. Lights
Replacing the Headlights
Specification: GE #862
1. Set the parking brake, turn the ignition off, and
remove the key.
2. Switch the headlights off.
3. Reach beneath the dash and rotate the
lamp assembly 1/4 turn counterclockwise
(Figure 39).
Figure 39
1. Lamp assembly
2. Reector
4. Pull the lamp assembly out of the reflector.
5. Remove the lamp assembly from the wire
harness.
6. Discard the lamp assembly.
7. Push the replacement lamp assembly onto the
wire harness.
8. Reach beneath the dash and align the three
tabs on the lamp assembly with the slots in the
reflector (Figure 39).
9. Insert the lamp assembly into the reflector and
rotate it 1/4 turn clockwise until it stops.
3. Power point
4. Low oil light and hour
meter
3. Tabs
4. Slots