Greasing And Lubricating The Machine; Cleaning The Cooling System - Toro 30527 Operator's Manual

Greasing and Lubricating the
Machine
Service Interval/Specification
Grease the areas shown at the intervals given in the Where
to Add Grease section below. Grease more frequently when
operating conditions are extremely dusty or sandy.
Grease with No. 2 general-purpose lithium-base or
molybdenum-base grease.
Applying the Grease
1. Disengage the PTO and set the parking brake.
2. Stop the engine and wait for all moving parts to stop
before leaving the operating position.
3. Clean the grease fittings with a rag and scrape any paint
from the front of the fittings.
4. Connect a grease gun to the fitting and pump grease
into the fittings until grease begins to ooze out of the
bearings.
5. Wipe up any excess grease.
Locating Where to Apply Grease
1. Lubricate the caster wheel bearings and front spindles
every 8 operating hours (Fig. 43).
2. Lubricate the mower deck idler pivot, pump drive idler
pivot and pump control every 40 operating hours
(Fig. 43).
Note: You'll have to remove the carrier covers to access the
grease fitting for the deck.
3. Lubricate the PTO engagement bellcrank every 100
operating hours (Fig. 43).

Cleaning the Cooling System

Service Interval/Specification
Before each use, check and clean engine cooling system.
Remove any build–up of grass, dirt or other debris from the
cylinder and cylinder head cooling fins, air intake screen on
flywheel end, and carburetor–governor levers and linkage.
This will help ensure adequate cooling and correct engine
speed and reduce the possibility of overheating and
mechanical damage to the engine.
33
Figure 43