Operating Neutral Locks; Operating Mower Blade Control (Pto) - Toro 30527 Operator's Manual

5. To stop the engine, pull the throttle all the way back to
stop (Fig. 20).
1
Figure 20
1. Throttle lever
Important
Make sure fuel shut off valve is closed
before transporting or storing machine, as fuel leakage may
occur.
Before storing machine, pull wire off spark plug(s) to
prevent possibility of accidental starting.

Operating Neutral Locks

Always set the neutral lock when you stop the machine.
Chock or block wheels if it is left unattended.
Setting the Neutral Lock
1. Squeeze the drive levers back.
2. Place thumbs on the upper part of of locks and move
them back (Fig. 21).
Releasing the Neutral Lock
1. Squeeze the drive levers back.
2. Place thumbs on the upper part of of locks and move
them forward until in forward slot (Fig. 21).
6
5
m–6487
1. Handle
2. Neutral lock
3. Neutral position
Operating Mower Blade
Control (PTO)
The blade control knob (PTO) is used in conjunction with
the Operator Presence Control (OPC) levers to engage and
disengage the mower blades.
Engaging the Mower Blades (PTO)
1. To engage blades, squeeze the Operator Presence
Control (OPC) levers against handle grips (Fig. 22).
2. Pull blade knob (PTO) up. Hold the OPC levers against
handle grip.
1. Handle
2. Operator Presence
Control levers (OPC)
20
2
1
3
4
Figure 21
4. Drive lever
5. Full speed forward
6. Reverse position
3
Figure 22
3. Blade control knob (PTO)
4. Drive Lever
m–5388
2
1
4
m–6487