Installing The Front Casters; Installing The Upper Handle - Toro 30527 Operator's Manual

Installing the Front Casters

1. Align the casters with the holes on the top and front of
the mower, and insert 8 bolts (3/8 x 3/4 inch) through
the mower. Secure the caster with 8 flange nuts
(3/8 inch) below the mower (Fig. 2).
3
Figure 2
1. Front caster
2. Bolt
Note: Tighten the lower bolts first to pull the caster
against the front, then tighten the top bolts.
2. Torque the bolts to 30–35 ft-lb (40–47 NSm).

Installing the Upper Handle

1. Align the holes in upper handle with the mounting holes
in the rear frame and bracket (Fig. 3).
1
2
m–3777
3. Flange nut
1. Upper handle
2. Rear frame bracket
3. Flange bolt (26 mm)
Important Install the flange bolts with the bolt head on
the outside of the upper handle. Refer to figure 3.
2. Secure each leg of the upper handle to the rear frame
and bracket with two flange bolts (3/8 x 1 inch
(26 mm), spring washers and flange nuts (Fig. 3).
Tighten until spring washers are compressed.
3. Route the wire harness along the inside of the left
handle and under the control panel (Fig. 17).
4. Connect the right-angled insulated terminals to the
switch (Fig. 4).
1
2
1. Switch
5. Use the wire ties to secure the wire harness to the inside
of the left handle, away from the blade control (PTO)
rod (Fig. 17). Secure at bottom and top of handle.
13
5
2
1
4
3
Figure 3
4. Spring washer
5. Flange nut
m–6490
Figure 4
2. Right-angled insulated
terminals
m–5969