Lcd Monitor Display/Switching The Lcd Monitor Display - Panasonic DMC-FX33 Operating Instructions Manual

Preparation
LCD Monitor Display/
Switching the LCD
Monitor Display
∫ Screen display in normal picture
mode [ ] (at the time of purchase)
1 2 3 4 5 6 7
13
F2.8 1/30
12 11
1 Recording mode
2 Flash mode (P34)
• If you press the shutter button halfway
when the flash is activated, the flash
icon turns red.
3 AF area (P21)
• The AF area displayed is bigger than
usual when taking pictures in dark
places.
4 Focus (P21)
5 Picture size (P61)
6 Quality (P61)
: Jitter alert (P23)
7 Battery indication
• The indication turns red and blinks if
the remaining battery power is
exhausted. (The status indicator blinks
when the LCD monitor turns off.)
Recharge the battery or replace it with
a fully charged battery.
• It does not appear when you use the
camera with the AC adaptor
(DMW-AC5G; optional) connected.
8 Number of recordable pictures (P113)
9 Recording state
10 Built-in memory/Card
20
VQT1K01
• The access indication lights red when
pictures are being recorded on the
built-in memory (or the card).
– When using the built-in memory
– When using the card
• Do not do the following when the
access indication lamps lights. The
8
card or the data on the card may be
9
damaged and this unit may no longer
operate normally.
10
– Turn this unit off.
– Remove the battery or the card.
(when using a card)
– Shake or bump this unit.
– Disconnect the AC adaptor.
(DMW-AC5G; optional) (when using
the AC adaptor)
• Do not do the above when pictures are
being read or deleted or the built-in
memory (or the card) is being
formatted. (P91)
• The access time for the built-in
memory may be longer than the
access time for a card.
11 Shutter speed (P21)
12 Aperture value (P21)
• If the exposure is not adequate, the
aperture value and the shutter speed
turn red. (They do not turn red when
the flash is activated.)
13 Optical Image Stabilizer (P64)
• Refer to P101 for information about other
screen displays.
∫ Switching the screen display
You can change the screen display by
pressing [DISPLAY]. This allows you to
display information while taking pictures
such as the picture size or the number of
recordable pictures or take pictures without
displaying any information. Refer to P31 for
details.