Taking Pictures Using The Built-In Flash - Panasonic DMC-FX33 Operating Instructions Manual

Advanced (Recording pictures)
∫ Cancelling setting
If you press and hold [LCD MODE] again
for 1 second the screen shown in step
displayed. Select [OFF] to cancell a setting.
• High angle mode is also cancelled if you
turn the camera off or power save mode is
activated.
• The brightness of the pictures displayed
on the LCD monitor screen are increased
in Auto Power LCD, Power LCD and High
angle modes. Therefore, some subjects
may look different on the LCD monitor.
However, this does not affect the recorded
pictures.
• The LCD monitor automatically returns to
normal brightness after 30 seconds when
recording in Power LCD mode. Press any
button to make the LCD monitor bright
again.
• If the screen is difficult to see because of
light from the sun etc. shining on it, use
your hand or another object to block the
light.
• Auto Power LCD and High angle mode
are not activated in the following cases.
– When the clipboard is playbacked in
clipboard mode [ ]
– In playback mode [ ]
– In print mode [ ]
– While the menu screen is displayed
– While the review screen is displayed
34
VQT1K01
Taking Pictures using
the Built-in Flash
2
is
A Photo flash
Do not cover it with your fingers or other
objects.
∫ Switching to the appropriate flash
setting
Set the flash to match the recording.
1 Press 1 [ ].
2 Press 3/4 to select a mode.
• You can also press 1 [ ] to select.
• For information about flash settings that
can be selected, refer to "Available flash
settings by recording mode". (P36)
3 Press [MENU/SET].
• You can also press the shutter
button halfway to finish.
• The menu screen disappears after
about 5 seconds. At this time, the
selected item is automatically set.