Do you have a question about the lste523 and is the answer not in the manual?
Questions and answers
Larry Althaus
May 24, 2025
how to install and and take off guard
1 comments:
Mr. Anderson
May 26, 2025
To install the guard on a Black & Decker LSTE523:
1. Engage the guard ribs with the motor housing. 2. Slide the guard on until you hear it “snap” into place. 3. Ensure the locking tab snaps into the housing slot. 4. Use a Phillips screwdriver to insert and securely tighten the guard screw. 5. Remove the covering from the line cut-off blade on the edge of the guard.
To remove the guard, reverse the installation steps.
This answer is automatically generated
Gale
March 30, 2025
Where can I get a motor for LST 523
1 comments:
Mr. Anderson
March 31, 2025
The document does not mention where to buy a motor for the Black & Decker LST523. However, it states that replacement parts like guards and spool caps are available at Black & Decker authorized service centers. You can call 1-800-544-6986 or visit www.blackanddecker.com to find a service center.
Need help?
Do you have a question about the lste523 and is the answer not in the manual?
Questions and answers
how to install and and take off guard
To install the guard on a Black & Decker LSTE523:
1. Engage the guard ribs with the motor housing.
2. Slide the guard on until you hear it “snap” into place.
3. Ensure the locking tab snaps into the housing slot.
4. Use a Phillips screwdriver to insert and securely tighten the guard screw.
5. Remove the covering from the line cut-off blade on the edge of the guard.
To remove the guard, reverse the installation steps.
This answer is automatically generated
Where can I get a motor for LST 523
The document does not mention where to buy a motor for the Black & Decker LST523. However, it states that replacement parts like guards and spool caps are available at Black & Decker authorized service centers. You can call 1-800-544-6986 or visit www.blackanddecker.com to find a service center.
This answer is automatically generated