Figure 46
Figure 47
5. If the ends of the levers hit against each other,
adjust the levers by rotating them out to the
neutral locked position and carefully bend
them outward. Repeat this step as needed.
Adjusting the Tracking
1. If the machine turns right or left when the
handles are pushed forward together, adjust
the stop on the side opposite that the machine
turns.
2. Loosen the bolt located in front of the control
lever.
3. Move the stop until the machine drives straight
(Figure 48).
4. Tighten the bolt located in front of the control
lever (Figure 48).
Figure 48
1. Control lever
2. Stop
Hydraulic System
Maintenance
Servicing the Hydraulic
System
Checking the Hydraulic Fluid
Fluid Type: Mobil 1 15W-50 synthetic motor oil or
equivalent synthetic oil.
Important: Use oil specified or equivalent.
Other fluids could cause system damage.
Check the hydraulic fluid level:
• Before the engine is first started.
37
3. Bolt in front of the control
lever