7 Maintenance
7.1
Maintenance plan
7.2.1 Emptying dirt tank
7.2.2 Replacing the safety filter bag
7.2.3 Replacing the filter bag
7.2.4 Replacing the disposal bag
7.2.5 Replacing filter element (H) (Push&Clean)
7.2.6 Replacing filter element (H) (XtremeClean)
7.2.7 Replacing filter element (M) (Push&Clean)
7.2.8 Replacing filter element (M)(XtremeClean)
7.2
Maintenance work
7.2.1 Emptying the dirt tank
After emptying the tank: clean the
rim of the tank and the seals in the
intermediate ring and the upper sec-
tion of cleaner before refitting them.
If the seal or groove is dirty or dam-
aged, the suction performance will
be reduced.
Before reinserting the suction hose:
clean the inlet fitting and hose col-
lar.
After finishing work
A
A
When required
1.
Switch off the vacuum clean-
er and pull the mains plug
out of the socket.
2.
Open the retaining clamps (A)
and remove the upper sec-
A
tion of the vacuum cleaner.
4.
Tip out the collected dirt.
5.
Dispose of the dirt in accord-
ance with legal regulations.
6.
Attach the upper section of
the vacuum cleaner.
7.
Close the retaining clamps
(B). Ensure that the retaining
clamps fit properly.
A
ATTIX 30-50 H/M
17