Resetting Your Speaker - Denon HEOS 3 HS2 Owner's Manual

Contents

Resetting your speaker

Resetting your speaker will clear out the wireless network info, EQ, and name but retain it's current software. You will have to use
Settings - Add Speaker to reconnect the speaker to your home network before it can be used.
To reset your speaker, press and hold the Connect and Bluetooth buttons located on the back of the HEOS speaker for 5 seconds
until the front LED begins to flash amber.
Restoring the speaker to factory defaults
Restoring the HEOS speaker to its factory defaults will clear all of the settings and restore the original software which was installed
at the factory.
Caution
All settings will be erased and the software will likely be downgraded!
0
To restore your HEOS speaker to the factory defaults, unplug the power cable from the back of the HEOS speaker. Press and
hold the Bluetooth button located on the back of the HEOS speaker, reconnect the power cable, and hold it in until the front LED
begins to flash amber.
* For further information, please visit HEOSbyDenon.com
Setup Use
Solution
Solution
Troubleshooting
57
Status LED Appendix
Refer to Page
Refer to Page
–
–