Connecting To A Wps Network; Resetting Your Speaker - Denon HOME 150 NV Owner's Manual

Contents

Connecting to a WPS network

If your wireless router support WPS (Wi-Fi Protected Setup™) your speaker can optionally connect to your network using the "Push Button" method by
0
following these steps:
Wi-Fi Protected Setup™ is trademarks of Wi-Fi Alliance.
1. Press the WPS button on your router.
2. Within 2 minutes, press and hold the CONNECT button on the rear panel of the speaker for 5 seconds.
3. The LED on the front of the speaker will flash green for several seconds as it connects to your WPS router.
4. When the connection is complete, the LED on the front of the speaker will turn solid blue.

Resetting your speaker

Resetting your speaker will clear out the wireless network info, EQ, and name but retain it's current software. You will have to use "Settings" - "Add
0
Device" to reconnect the speaker to your home network before it can be used.
To reset your speaker, press and hold the CONNECT and Bluetooth (V) buttons located on the rear panel of the speaker for 5 seconds until the front
LED begins to flash amber.
Buttons do not operate correctly
Do not put anything on top of the speaker.
0
Items near the top of the speaker (curtains, steel racks, etc.) may cause unintended button activation.
0
Set up the speaker where there is nothing nearby.
0
Unplug the power cord before cleaning the top panel.
0
Setup Playback Troubleshooting
35
Status LED Appendix