Bake And Broil Solenoids - Viking VGSO100 Service Manual

30” gas single wall oven

Hide thumbs Also See for VGSO100:

Table of Contents

Service Procedures

Bake and Broil Solenoids

The bake and broil solenoids provide a means to open the gas valve. When the

DSI module receives 120 VAC input, the voltage is stepped down to 8 to

18 VDC and output to the appropriate bake or broil solenoid. This voltage is

sufficient to open the gas valve and allow gas to ﬂow to the burner.

NOTE: The solenoids are sized for special voltage and current. DO NOT use

voltage above 8 to 18 VDC to operate the solenoids.

To access the bake and broil solenoids, remove the unit form installation and

remove the rear cover. The bake and broil solenoids are located on the right

hand side when viewed from the rear. The ower solenoid is for bake and the

upper solenoid is for broil.

Test Procedures –

Bake and Broil Solenoids

Remove power to the unit.

Set the Volt-Ohm meter to read resistance.

Measure resistance at bake solenoid terminals.

The Volt-Ohm meter should read 215 ohms +/- 30 ohms.

Table of Contents

Show Quick Links

Table of Contents