Carrier 40GJB Owner's Manual page 7

How to use the remote control to operate the unit
11 QUIET:
Press this button, the Quiet status is under the Auto Quiet mode (display
and Quiet mode (display "
after powered on, the Quiet OFF is defaulted. Note: the Quiet function cannot be set up in Fan
and Dry mode;Under the Quiet mode (Display "
12 CLOCK :
Press CLOCK button, blinking
present time.Holding down either button above 2 seconds increases or decreases the
time by 1 minute every 0.5 second and then by 10 minutes every 0.5 second. During
blinking after setting, press CLOCK button again to confirm the setting,and then
will be constantly displayed.
T-ON T-OFF:
13
Press T-ON button to initiate the auto-ON timer. To cancel the auto-timer program, simply
press this button again.
After press of this button,
setting. Within 5 seconds, press + or - button to adjust the time value. Every press of either
button changes the time setting by 1 minute. Holding down either button rapidly changes the
time setting by 1 minute and then 10 minutes. Within 5 Seconds after setting, press TIMER
ON button to confirm.
Press T-OFF button to initiate the auto-off timer. To cancel the auto-timer program, simply
press the button again.TIMER OFF setting is the same as TIMER ON.
TURBO:
14
Press this button to activate / deactivate the Turbo function which enables the unit to
reach the preset temperature in the shortest time. In COOL mode, the unit will blow strong
cooling air at super high fan speed. In HEAT mode, the unit will blow strong heating air
at super high fan speed.
15 LIGHT:
Press LIGHT button to turn on the display's light and press this button again to turn off
the display 's light. If the light is turned on ,
disappears.
X-FAN:
16
Pressing X-FAN button in COOL or DRY mode,the icon
fan will continue operation for 10 minutes in order to dry the indoor unit even though you
have turned off the unit.
After energization, X-FAN OFF is defaulted. X-FAN is not available in AUTO,FAN or
HEAT mode.
Combination of "+"
17
Press "+ " and "-" buttons simultaneously to lock or unlock the keypad. If the remote
controller is locked,
three times.
" singal) and Quiet OFF (there is no signal of "
. Within 5 seconds,pressing +or - button adjusts the
disappears and "ON "blinks .00:00 is displayed for ON time
and "-" buttons: About lock
is displayed. In this case, pressing any button,
6
" signal), the fan speed is not available.
is displayed. If the light is turned off,
is displayed and the indoor
OPERATION INSTRUCTIONS
" " and "Auto" signal)
" displayed),
blinks