ShenZhen GETECH CO.,LTD
www.geeetech.com
After pushing the filament into the bottom of hotend, use the feeding button on Repetier (as shown
in following picture) to do manual feeding. If the nozzle can extrude filament fluently, the extruder
is working well. If not, please refer to FAQ.
Note: If the moving direction of the motor is reversed, which means you found the filament going
backwards when you click to feed downwards, change the motor direction of the extruder in the
firmware to solve the problem. This method is the same with that for X/Y/Z axis motor.
15