Checking The Ink Status With The Ink Lamps - Canon MG7100 series Online Manual

Checking the Ink Status with the Ink Lamps

1. Make sure that the power is turned on, then, holding both sides of the
paper output tray, gently open it.
2. Lift the operation panel and open until it stops.
Replacing Procedure
3. Check the ink lamp.
Close the operation panel after checking the ink lamp status.
Replacing Procedure
The ink lamp is on.
The ink tank is correctly installed.
The ink lamp is flashing.
Flashing slowly (at around 3-second intervals)
Ink tank is running low. Prepare a new ink tank.
Flashing fast (at around 1-second intervals)
- The ink tank is installed in the wrong position.
Or
- The ink has run out.
Make sure that the ink tank is installed in the correct position as indicated by the
label on the print head holder. If the position is correct but the lamp flashes, there
has been an error and the machine cannot print. Check the error message displayed
on the touch screen.
A Message Is Displayed
...... Repeats
...... Repeats
181