Inserting The Memory Card - Canon MG7100 series Online Manual

Inserting the Memory Card

Important
When a memory card is inserted into the card slot, the Access lamp is lit. When the
Access lamp is flashing, the machine is accessing the memory card. In this case, do
not touch the area around the card slot.
Note
When Read/write attribute is set to Writable from USB PC or Writable from LAN PC,
you cannot print image data from the memory card or save scanned data on the
memory card using the operation panel of the machine. After using the card slot as the
memory card drive of a computer, remove the memory card, select Device user
settings in Device settings of Setup on the HOME screen, then set Read/write
attribute to Not writable from PC.
Setting Up the Card Slot as the Memory Card Drive of the Computer
When you use a computer to edit or enhance photos saved on a memory card, be sure
to print them from the computer. If you use the operation panel, the photos may not be
printed properly.
1. Prepare your memory card.
Attach a special card adapter if your memory card requires one.
Before Inserting the Memory Card
2. Turn on the power, then, holding both sides of the paper output tray,
gently open it.
3. Insert only one memory card into the card slot.
The location to insert a memory card varies depending on each type of memory card.
Insert your memory card straightforward WITH THE LABELED SIDE FACING TO THE
LEFT into the card slot, according to the insert location in the figure below.
When the memory card is inserted properly, the Access lamp
168
(A) will light up.