Denon PMA-2500NE Owner's Manual page 38

Contents Connections
o Playback
Install the desired player software on your computer beforehand.
Use the rear panel USB-DAC port to connect this unit to a computer.
1
Press INPUT SELECT to switch the input source to
"USB-DAC".
"USB-DAC" is displayed on the display of this unit.
Start playback on the computer's player software.
The digital audio signal that is being input is shown as follows in the
display.
"USB: PCM
xxxxkHz"
(xxxx is the sampling frequency.)
If the sampling frequency cannot be detected, "Unlocked" will be
0
displayed.
"Unsupported" is displayed when audio signals that are not
0
supported by this unit are input.
Front panel Rear panel
Playback
"USB: DSD
or
xxxMHz"
Remote control
unit
Settings
o Files that can be played back
See "D/A converter" (v p. 50).
NOTE
0 Perform operations such as playback and pause on the computer. At this time, you
cannot perform operations with buttons on this unit or the remote control.
0 When this unit is functioning as a D/A converter, sound is not output from the
computer's speakers.
0 If the computer is disconnected from this unit while the computer music playback
software is running, the playback software may freeze. Always exit the playback
software before disconnecting the computer.
0 When an error occurs on the computer, disconnect the USB cable and restart the
computer.
0 The sampling frequency of the music playback software and sampling frequency
displayed on this unit may differ.
0 Use a cable that is 3 m or less to connect to the computer.
38
Index
Tips Appendix