KTM 125 Duke Owner's Manual page 118

13 WHEELS, TIRES
–
Install the rubber damper and rear sprocket carrier on the rear wheel.
–
Position the rear wheel.
The brake linings are correctly positioned.
–
Push the rear wheel as far forward as possible and place the chain on the rear
sprocket.
–
Pull the rear wheel back and mount wheel spindle
adjuster
Guideline
Mount the left and right chain adjusters
–
Mount nut
–
Push the rear wheel forward so that the chain adjusters are on the screws, and
tighten nut
Guideline
In order for the rear wheel to be correctly aligned, the markings on the left and
right chain adjusters must be in the same position relative to the reference
marks
Nut, rear wheel spindle
–
Position wheel speed sensor
–
Mount and tighten screw
Guideline
S00674-11 Screw, wheel speed sensor holder
Finishing work
–
Take the motorcycle off of the rear wheel stand. (
–
Check the chain tension. (

.

and washer.

.

.

in the drill hole.
 .
p. 84)

with the washer and chain

in the same position.
M14x1.5 90 Nm
(66.4 lbf ft)
M6 8 Nm (5.9 lbf ft)
p. 77)
116