Adjusting The Basic Position Of The Foot Brake Lever - KTM 2016 690 DUKE Owner's Manual

13 BRAKE SYSTEM
13.8

Adjusting the basic position of the foot brake lever

Warning
Danger of accidents Brake system failure.
–
If there is no free travel on the foot brake lever, pressure builds up on the rear brake circuit. The rear brake can fail due to over-
heating. Adjust the free travel on foot brake lever according to specifications.
–
Disconnect spring
–
Remove screw
–
Loosen nut
travel is reached.
–
To adjust the basic position of the foot brake lever to individual requirements, loosen
nut  and turn screw
Info
The range of adjustment is limited.
V00061-10
–
Turn ball joint
basic position of the foot brake lever.
Guideline
Free travel at foot brake lever
–
Hold screw
Guideline
Remaining nuts, chassis
–
Hold ball joint

.

.
 and turn it back with ball joint
 accordingly.

as required until free travel
 
and tighten nut .
 
and tighten nut .
 until the maximum amount of free

is reached. If necessary, adjust the
3... 5 mm (0.12... 0.2 in)
M6 10 Nm (7.4 lbf ft)
100