Residual Risks; Specification - Ryobi RLT26C Operator's Manual

Comply with local regulations in the use of the product.
WARNING
Injuries may be caused, or aggravated, by
prolonged use of a tool. When using any tool
for prolonged periods, ensure you take regular
breaks.
SPECIFIC SAFETY RULES FOR TRIMMER USE
Replace string head if cracked, chipped, or damaged
in anyway. Be sure the string head is properly installed
and securely fastened. Failure to do so can cause
serious injury.
Make sure all guards, straps, deflectors and handles
are properly and securely attached.
Use only the manufacturer's replacement line in the
cutting head. Do not use any other cutting attachment.
Failure to do so can result in serious personal injury.
Never operate unit without the safety guard in place
and in good condition.
Maintain a firm grip on both handles while trimming.
Keep string head below waist level. Never cut with
the string head located over 76 cm or more above the
ground.
WARNING
Inspection after dropping or other impacts:
Thoroughly inspect the product and identify any
affections or damage with it. Any part that is
damaged should be properly repaired or replaced
by an authorized service centre

RESIDUAL RISKS

Even when the machine is used as prescribed, it is still
impossible to completely eliminate certain residual risk
factors. The following hazards may arise in use and
the operator should pay special attention to avoid the
following:
Injury caused by vibration. Hold the tool by designated
handles and restrict working time and exposure.
Exposure to noise can cause hearing injury. Wear ear
protection and limit exposure.
Eye injury due to flying debris. Wear eye protection
at all times.

SPECIFICATION

Weight
- Without fuel and cutting attachment
- Without fuel with string head
English (Original Instructions)
Fuel tank volume
Cutting swath
Engine displacement
Line diameter
Maximum engine performance (in
accordance with ISO 8893)
Maximum rotational frequency of the
spindle
Engine speed (rotational frequency) at
recommended max. spindle rotational
frequency
Engine speed (rotational frequency) at
idle
Fuel consumption (in accordance with
ISO 8893) at max. engine performance
accordance with ISO 8893) at max.
engine performance
Vibration (in accordance with ISO 22867):
Front handle
- Idling
- Racing
- Equivalent vibration total value
Rear handle
- Idling
- Racing
- Equivalent vibration total value
Uncertainty K
Noise emission (in accordance with ISO 22868)
A-weighted emission sound pressure
level at the operator position
- Idling
- Racing
- Equivalent A-weight emission sound
pressure level
A-weighted sound power level
4.4 kg
- Idling
4.6 kg
4
250 cm or
3
(0.25L)
432 mm
26 cm / cc
3
2.4 mm
0.65 kW
12,000 min
-1
12,000 min -1
2,800-3,800
min -1
0.33 kg/h or
(0.45 L/h)
508 g/kW.h
or (0.7 L/
kW.h)
4.4 m/s
2
14.0 m/s 2
10.4 m/s 2
5.7 m/s 2
8.7 m/s 2
7.4 m/s
2
1.5 m/s 2
72.5 dB (A)
99.0 dB (A)
96.0 dB (A)
85.4 dB (A)