Fuel Mix And Fuelling; Fuelling And First Use Preperation - Oregon JW3800 Assembly And Operation Manual

FUEL MIX AND FUELLING

Mix a regular grade petrol (LEADED OR
UNLEADED, ALCOHOL FREE) and a good quality
motor oil designed for air cooled 2 cylinder
engines.
RECOMMENDED MIXING RATIO PETROL
25:1 OIL
When using for the first time, remember that
engine problems can be caused by using an
incorrect fuel mix or using the wrong type of
petrol / oil
Fuelling and first use preparation
! When refuelling the tank ensure the engine is
off and check your surroundings for signs of
danger (open flames, sparks).
! Use a dry rag to mop up any spillages
! After refuelling carry the product away from
the refuelling location before use.
*Please note that the correct fuel mix ratio is
printed on the label located in the handle area
The chainsaw must be tipped on its side when
filling, not doing this will cause the fuel tank to
overspill. To prevent spillage a small funnel can
be used.
The petrol cap is clearly marked on the unit.
Rotate the cap Anti clockwise to release and add
your fuel mix to the engine. Then replace the
cap and rotate clockwise until secured tightly.
Chain oil should be added to the unit before first
use. It can be topped up as required.
Remove the chain oil cap (shown below) by
turning the cap anti-clockwise.
5