Table of Contents
Advertisement
Read these instructions completely and
IMPORTANT—Observe all governing
codes and ordinances.
ELECTRICAL REQUIREMENTS
FOR PERSONAL SAFETY:
THIS APPLIANCE MUST BE PROPERLY
GROUNDED. See page 3.
DO N~, UNDER ANY CIRCUMSTANCES,
CUT OR REMOVE THE THIRD
GROUNDING PRONG FROM THE
POWER CORD.
WE RECOMMEND THAT YOU DO
NOT USE AN EXTENSION CORD OR AN
ADAPTER PLUG WITH THIS APPL~CE.
DO NOT CHANGE THE PLUG ON THE
POWER CORD OF THIS APPLIANCE.
FOLLOW NATIONAL ELECTRICAL
CODES OR LOCAL CODES AND
ORDINANCES.
15 AMP circuit
20 AMP circuit
"parallel" type
"perpendicular"
type
If the electric supply provided does not meet the
above specifications, all a licensed electrician.
. Aluminum house wiring may pose special
problems—consult a qualified electrician.
This unit requires a separate circuit serving only
this appliance.
BEFORE YOU BEGIN
15 AMP circuit
30 AMP circuit
"tandem" type
"tandem" type
INSTALLER—Be sure to leave these
instructions with the Consumer.
CONSUMER—Keep these instructions for
future reference.
WINDOW REQUIREMENTS
Standard double-hung window with actual
opening width of 331/4" to 46!'
Clear vertical opening of 191/2" minimum from
bottom of sash to stool.
Install the air conditioner in a window where
there will be enough clearance around the cabinet
to allow ample circulation of air through the unit.
min.
Note:
All supporting parts should be
secured to firm wood, masonry or metal.
TOOLS NEEDED
Phillips screwdriver
Blade-type screwdriver
Scissors or knife
Drill
1/8" drill bit
Tape measure
Advertisement
Table of Contents
