Air Direction - GE ACV24D Use And Care & Installation Manual

For normal cooling
1.
Set the Selector Switch at HI
COOL.
2. Set the Thermostat Control at
the desired number (usually 4-6 is
a good starting position). If room
temperature is not satisfactory
after a reasonable time, set the
Thermostat Control at a higher
number for a cooler room or at a
lower number for a warmer room.
3. Be sure the AIR IN and AIR
OUT buttons are in the out
position.
For maximum cooling
1.
Set the Selector Switch at HI
COOL.
2. Turn the Thermostat Control
to 8.
3. Be sure the AIR IN and AIR
OUT buttons are in the out
position.
1.
Set the Selector Switch at the LO
COOL position.
2. Turn the Thermostat Control to
the desird number.
When the Thermostat Control is set
on 7 or 8 and the Fan is set on low
speed, moisture may freeze on the
coils and prevent the unit from
cooling. If this happens, set the Fan
at high speed and set the Thermostat
Control to a lower number.
3. Be sure the AIR IN and AIR
OUT buttons are in the out position.
For ni@ttime operation
During the cooler evening hours,
we recommend that you set the
Selector Switch at LO COOL
for quieter operation and the
Thermostat Control at mid-range
(4 or 5).
For extreme temperatures
For greatest economy and best
performance, we suggest you set
the Selector Switch at HI COOL in
extremely hot weather.
For ventilation
Whether the controls are set for
cooling or fan only operation,
setting the Ventilation Control at
AIR IN allows a small amount of
outside air to enter the room, and
setting it to AIR OUT lets room
air be exhausted to the outside.
However, cooling effectiveness is
reduced whenever the vent door is
open, so we suggest that you don't
keep it open for long—especially
in hot. humid weather.
To adjust air direction
Up and down
"'
-----
— ..- —
The up-and-down air direction
louvers are controlled by fingertip
pressure on the louvers. They
regulate air discharge upward,
downward or straight out.
Side to side
OFF
For fixed side-to-side air
direction, set the Circulaire Switch
to ON until the desired air direction
is obtained, then move it to OFF.
For continuous side-to-side air
circulation, set the Circulaire
Switch to ON and leave it there.
5