Table of Contents
Advertisement
15.
Inspect area around vehicle before moving, especially in
reverse. Back up slowly. Always look down and behind
before and while backing to avoid a back-over accident.
Keep bystanders out of area.
16.
Avoid driving through water, since loss of control may
occur. Drive belt may slip if exposed to water thus reducing
vehicle pulling power and stopping vehicle entirely.
17.
Always use vehicle lights while operating in low light situations.
18.
Do not mount or leave vehicle while it is in motion or in
actual operation.
19.
Avoid sudden starts, stops, or turns and always use a level
turn-around area.
20.
Never leave vehicle unattended with the key in the ignition.
Always turn key to the "Stop" position, set the parking
brake and remove key.
21.
Check overhead clearances carefully before driving under
low hanging tree branches, wires, power lines, bridges,
before entering or leaving buildings, or in any other situation
where the operator and/or operator protective structure
(OPS) may be struck, which could result in serious injury.
22.
Use the operator protective structure (OPS) and seat belt
for safe operation. Overturning the utility vehicle without
a operator protective structure (OPS), or with a operator
protective structure (OPS) and the seat belt unfastened,
can result in death or injury.
23.
Always use the seat belt, except if the operator protective
structure (OPS) has been removed.
24.
The doors are designed to assist in keeping the operator
and passenger inside the vehicle during operation. Do not
operate vehicle without doors in place.
25.
Improper use of the vehicle or failure to properly maintain
it could result in decreased vehicle performance or
personal injury.
26.
Engine must be stopped when cleaning, servicing,
adjusting, repairing, or installing attachments on utility
vehicle.
27.
After striking foreign objects, stop the unit and shut off the
engine. Inspect for damage and repair the damage before
restarting and operating equipment.
28.
Do not start or operate vehicle in an inside area, unless it
is adequately ventilated. Engine exhaust contains carbon
monoxide fumes, which are very poisonous and can be
deadly.
29.
Do not change engine governor setting or over speed the
engine. The governor is set at the factory for safe operating
speed.
30.
Assure safety interlock switch is adjusted correctly so
engine cannot be started unless gearshift is in the neutral
position.
31.
Do not touch engine or muffler while engine is running or
soon after it is stopped. They will be hot and can cause a
burn.
32.
Always inspect your vehicle each time you use it to make
sure it is in safe operating condition. Always follow the
inspection and maintenance procedures and schedules
described in this manual.
4
S
2 — i
ection
mportant
S
o
p
afe
peration
racticeS
33.
If situations occur which are not covered in this manual,
use care and good judgement. Contact your local service
center or call toll free 1-877-282-8684 for the name of your
nearest service center.
Slope Operation
Slopes are a major factor related to loss of control and rollover
accidents, which can result in severe injury or death. If a slope is
steeper than a 15° incline, do not operate this unit on that area.
Exercise extreme caution while operating on slopes.
Do:
1.
Travel straight up and down slopes, not across. Exercise
extreme caution when changing direction on slopes.
2.
Travel slowly while on a slope. Always keep the forward
speed limited when going down slopes to take advantage
of the motor braking action.
3.
Keep all movement on the slopes slow and gradual. Avoid
starting or stopping on a slope.
4.
Avoid slopes with slippery, loose, or bumpy surfaces as
they are especially hazardous.
5.
Use extra care while carrying cargo. It may affect the
stability of the vehicle. Spread the load evenly or tie down.
Do Not:
1.
Do not travel near drop-offs, ditches or embankments. The
vehicle could suddenly turn over if a wheel is over the edge
of a cliff, ditch, or if an edge caves in.
2.
Do not stop or start suddenly when going uphill or
downhill. Be especially cautious when changing direction
on slopes.
3.
Do not turn sideways to the hill. The vehicle may roll over. If
you must turn, go slow and do so carefully and gradually.
4.
Do not carry cargo on steep slopes or tow loads.
Towing
1.
Always use an approved hitch and hitch point provided on
the utility vehicle.
2.
Do not tow more than 1400 lbs. rolling weight (i.e. trailer
plus cargo).
3.
Never load more than 140 lbs. tongue weight on tow
bracket provided.
4.
Go slow and use extra care when towing a trailer. Allow for
increased braking distance. Load trailer properly.
5.
Do not tow heavy loads on slopes greater than 5° incline.
When going downhill or turning, the extra weight tends to
push the tow vehicle and may cause you to loose control
(i.e. braking and steering ability are reduced, towed
equipment may jack-knife and cause utility vehicle to
overturn).
Cargo Box Loading/Operation
1.
Do not exceed vehicle's Total Load Capacity rating of 1,400
lbs. This includes operator, passenger, accessories, and
cargo.
2.
Do not exceed 1000 lbs. load in cargo box.
Hide quick links:
Advertisement
Table of Contents
