Table of Contents
Advertisement
Warranty and service
Information code
C0
C1
C2
A2
d0
F0
F2
What should I do if the cooking zone will
not switch on or off?
This could be due to one of the following
possibilities:
•
The control panel is partially covered by
a damp cloth or liquid.
•
The child safety lock is on.
What should I do if the
illuminated?
Check for the following:
•
The control panel is partially covered by
a damp cloth or liquid.
To reset, press the On/Off control sensor.
If liquid has overflowd on control panel,
•
please wipe the liquid.
44 English
NZ63J9770EK_EF_DG68-00635A-00_EN.indd 44
Possible cause
Check the Auto Cook sensor.
The temperature is sensed higher
than specified.
Check the Auto Cook sensor.
The DC Motor fails to operate
because of problems with the PCB
or wiring, or electrical disturbance
on the motor blade.
The sensor is pressed for more
than 8 seconds.
Communications between main
and sub PCBs fail.
The touch-enabled IC
communicates abnormally.
display is
Solution
Restart the appliance using the Power
button. If the problem continues,
disconnect power for more than 30
seconds. Then, restart the appliance and
try again. If the problem still continues,
contact a local service center.
Check if the sensor pad is wet or pressed.
If the problem continues, restart the
appliance using the Power button. If the
problem still continues, contact a local
service center.
Restart the appliance using the Power
button. If the problem continues,
disconnect power for more than 30
seconds. Then, restart the appliance. If
the problem still continues, contact a local
service center.
What should I do if the
illuminated?
Check for the following:
•
The hob is overheated because of
abnormal operation.
After hob is cooled down, press the On/
•
Off control sensor for resetting.
What should I do if the
illuminated?
Check for the following:
•
Cookware is unsuitable or too small or
no cookware has been placed on the
cooking zone.
If you use suitable cookware, displayed
•
message will automatically disapear.
display is
display is
2015-01-15
2:43:38
Advertisement
Table of Contents
