Table of Contents
Advertisement
Hob use
To display the time remaining for any of
the cooking zones, use the Timer control
sensor.
The corresponding control indicator will
begin to blink slowly.
The settings are reset using the Timer
setting selectors (
period of time has elapsed, the cooking zone
automatically switches itself off, an acoustic
signal sounds as confirmation and the timer
display indicates.
Count up timer
For the count up timer to be used, the appliance must be switched on but all the cooking
zones must be not use timer as a safety shutoff.
34 English
NZ63J9770EK_EF_DG68-00635A-00_EN.indd 34
or
). After the set
4. To cancel the timer settings, select the
target burner and hold down the Timer
control
sensor for 2 seconds. This
will cancel the burner's timer settings
with a beep. If holding down the Timer
control
sensor for 2 seconds without
selecting a burner, this will cancel
the timer settings of the last changed
burner.
NOTE
If you tap the Timer control
without selecting a cooking zone, the
display turns on but no timer settings is
applied.
NOTE
To change the settings quicker, touch and
hold any of the
or
until the desired value is reached.
1. Touch the Timer control
will appear in the timer display.
2. The count up timer function becomes
active and the display numbers increase
over time. To cancel the timer settings,
hold down the Timer control
for 2 seconds.
3. To stop the timer, touch the Timer
control
sensor.
sensor
control sensors
sensor.
sensor
2015-01-15
2:43:28
Advertisement
Table of Contents
