The Normal Non-Fault Problems; Technical Information - Electrolux EWT654XW User Manual

THE NORMAL NON-FAULT PROBLEMS

PROBLEMS
Machine pauses during washing or rinsing
Water flowing in during washing or rinsing
Machine pause after water is fully drained
Spinning of the drum is intermittent or paused
during the initial spin cycle
Machine adds water into the drum during
spinning cycle
The control panel feels warm
The machines does not continue after power
supply recovers from sudden supply cut-off
Machine does not respond when buttons are
pressed
Some detergent residue in the detergent
drawer
Machine displays "So"
Machine displays "EC"

Technical Information

Model
Product Dimension (WxHxD) mm
Power supply : Vietnam / Indonesia
Malaysia / Singapore
Philippines
Rated Power
Water supply pressure (min-max) Mpa
Maxium load
Spin speed
POSSIBLE REASONS AND RELEVANT
SOLUTION
Machine is detecting water level which is normal operation.
The machine detects water level lower than required and
automatically top up water.
Spin cycle is delayed to ensure complete water drain which is
normal operation.
The machine program is designed with initial intermittent
spinning which is normal operation.
The washing load is unevenly distributed and machine is
redistributing the load.
This is normal as some electrial components generate heat
There has been continuous power supply cut-off and machine
goes into power off for protection purpose.
Child Lock option is activated. Unlock Child Lock to resume
normal operation of the control buttons.
Check the water supply pressure. The suitable water supply
pressure is 0.03-0.6MPa.
"SO" is not an error code and is displayed to remind users to
add softener to the wash tub. LED will show "SO" before the
last rinse and the buzzer will sound to prompt users to add
softener. How to remove the reminder adding softener: Open
the top lid and close it again for the machine to run next
program. If not, the machine will automatically run next
program after 42 seconds. Buzzing beat: The buzzing
resembles "di-di" (1s-1s) and will sound every 7 seconds.
"EC" is not an error code and only displayed during Eco
Program selection. EC is displayed when the remaining time
is above 99 minutes as the display can only shown up to 99
minutes. The display will change from "EC" to the actual time
when it falls to 99 minutes.
EWT654XW
530x920x550
220V~,50Hz
230-240V~,50Hz
230V~,60Hz
460W
0.03-0.6MPa
6.5kg
700 rpm(50HZ)/735 rpm(60HZ)
15
EWT754XW/XS
560x950x575
220V~,50Hz
230-240V~,50Hz
230V~,60Hz
520W
0.03-0.6MPa
7.5kg
EWT854XW/XS
580x950x600
220V~,50Hz
230-240V~,50Hz
230V~,60Hz
600W
0.03-0.6MPa
8.5kg