Table of Contents
Advertisement
TG7511CX(e).book Page 37 Wednesday, March 24, 2010 8:41 AM
Error messages
If the unit detects a problem, one of the following messages is shown on the display.
Display message
Cause/solution
L The handset has lost communication with the base
Base no power
or
No link to base.
L Unplug the base unit's AC adaptor to reset the unit.
Reconnect main
base AC adaptor.
L The handset's registration may have been cancelled.
L The supplied telephone line cord has not been
Check Phone Line
L Phonebook copy failed (page 19). Confirm the other
Failed
L The receiver's phonebook memory is full. Erase the
Incomplete
L The phonebook memory is full. Erase unnecessary
Memory Full
L The call barred list memory is full. Erase unnecessary
L The maximum number of base units (4) is already
L A wrong type of battery such as Alkaline or
Use rechargeable
battery.
L You must subscribe to a Caller ID service. Once you
You must first
subscribe to
Caller ID.
unit. Move closer to the base unit and try again.
Reconnect the adaptor and try again.
Re-register the handset (page 29).
connected yet or not connected properly. Check the
connections (page 8).
handset (the receiver) is in standby mode and try
again.
unnecessary phonebook entries from the other
handset (the receiver) and try again.
entries (page 19).
entries (page 28).
registered to the handset. Cancel unused base unit
registrations from the handset (page 29).
Manganese was inserted. Use only the rechargeable
Ni-MH batteries noted on page 3, 6.
receive caller information after subscribing to a Caller
ID service, this message will not be displayed.
Useful Information
37
Advertisement
Table of Contents
