Rear Panel Block - Sony HT-GT1 Service Manual

HT-GT1

2-11. REAR PANEL BLOCK

ire e i
MAIN board
rear
side
Rear panel block
5 Remove the rear panel block
in the direction of the arrow.
6 flexible flat cable (9P)
(CN3006)
7 rear panel
block
4 eight screws
(BVTP3 8)
16
clamp
CN4003
3 connector
(CN4003)
4 five screws
(BVTP3 8)
Note: When installing the flexible flat cable, ensure that
the colored line is parallel to the connector after insertion.
OK
Insert straight into the interior.
flexible flat
cable
colored line
connector
– Rear view –
NG
Insert at a slant.
flexible flat
cable
colored line
connector
2 Remove the wire
from the clamp.
1 Draw the cord bushing
out of the groove.