Table of Contents
Advertisement
Available languages
Available languages
Assembly & Setup
Contents of Carton
•
Tiller (1)
•
Operator's Manual (1)
Assembly
References to the right and left side of tiller are observed from
the operating position.
Handle
1.
Identify the forward and reverse clutch cables. See Figure 3-1.
Forward Clutch Cable
Figure 3-1
NOTE: Be sure not to kink cables while attaching.
2.
Hook the "Z" end of the forward clutch cable (A) into the
forward tine engagement lever. See Figure 3-2.
B
Figure 3-2
•
Handlebar Assembly (1)
•
Engine Operator's Manual (1)
Reverse Clutch Cable
A
•
Depth Gauge Assembly (1)
•
20 oz. Bottle 10w30 Oil (1)
3.
Hook the "Z" end of the reverse clutch cable (B) into the
reverse tine engagement lever. See Figure 3-2.
4.
Remove the hex bolt and cupped washer from the right
side of the frame. Hold the cable guide bracket on the left
side of the frame as it will fall when the bolt is removed.
Step 1 in Figure 3-3.
1
Figure 3-3
5.
Insert the handle into the tiller frame as shown in Step 2 of
Figure 3-3.
6.
Insert the bolt through the cupped washer, frame, handle
and into the cable guide bracket (note the notch in the
cable guide bracket goes over the flange on the frame.)
Step 3 in Figure 3-3.
3
2
3
7
Advertisement
Chapters
Table of Contents
