AKG so40 Manual page 9

2 Description
2.1 Introduction
Dear Customer:
Thank you for purchasing an AKG
product. This Manual contains important
instructions for setting up and operating
your equipment. Please take a few
minutes to read the instructions below
carefully before operating the equip-
ment. Please keep the Manual for future
reference. Have fun and impress your
audience!
2.2 Unpacking
1 AAA size
1 SO 40
battery
transmitter
Check that the package contains all the
parts listed above. If anything is missing,
please contact your AKG dealer.
2.3 Optional Accessories
2.4 Description
The SO 40 is a WMS 40 microtools
Series miniature transmitter specifically
designed for direct connection to a
microphone.
The transmitter features a 3-pin stan-
dard XLR connector that allows you to
connect the transmitter directly to a
dynamic microphone (e.g., AKG Emotion
Series) or a condenser microphone with
an internal power supply (e.g., AKG
1 black bat-
C 1000 S).
tery cover
CU 40 charger
The SO 40 operates on a single fixed,
quartz stabilized carrier frequency in the
710 MHz to 865 MHz UHF band and
uses a permanently attached flexible
antenna.
The color of the battery cover indicates
the carrier frequency of your transmitter.
You can replace the color code battery
cover with the supplied black replace-
ment cover.
2.5 Con n trols (Refer to fig. 1)
1 ON/MUTE/OFF: This slide switch
provides three positions:
ON: Power to the transmitter is on.
M: The signal delivered by the micro-
phone is muted while power and the
RF carrier frequency remain on. This
prevents the receiver from respond-
ing to interference from other trans-
mitters.
OFF: Power to the transmitter is off.
9