Ssd (M.2) - HP Pavilion Maintenance And Service Manual

SSD (M.2)

Description
Solid-state drive board
GNRC SSD 256GB 2280 M2 SATA-3 Value
GNRC SSD 128GB 2280 M2 SATA-3 Value
Solid-state drive cable
Before removing the SSD, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the base enclosure (see
components:
a. Battery (see
b. Optical drive (see
c. Hard drive (see
Remove the SSD:
1. Remove the Phillips M2.0 x 2.5 screw (1) that secures the SSD to the system board.
2. Remove the SSD (2) by pulling the drive away from the slot at an angle.
Reverse this procedure to install the SSD.
Base enclosure on page
Battery on page 30).
Optical drive (select products only) on page
Hard drive on page 31).
28), and then remove the following
26).
Component replacement procedures
Spare part number
856210-001
865902-001
847110-002
856353-001
33