The Rear Panel - Binatone SW-GE1008F User Manual

1）8 10Base-T/100Base-TX /1000Base-TX RJ-45 ports
The right side of the Console port is eight 10/100/1000 Mbps port, they support 10 Mbps, 100 Mbps or
1000Mbps bandwidth connection equipment, support Auto-Negotiation. To configure the speed control,
duplex control, safety control, flow control and the broadcast storm of each port by WEB management Each
port corresponding to a double color LED lights, red indicate 10/100M Link/Act, green indicate 1000M
Link/Act.
2）2 100/1000Mbps SFP ports
The right side of the front panel is 2 100/1000 Mbps SFP ports, each corresponding to a LED indicator, red
indicate 10/100M Link/Act, green indicate 1000M Link/Act.
3）1 console configuration port
Locating on the right side of LED indicator in the front panel,
it is the out-of-band management and computer connection interface, to configure the system information,
network parameter and safety management, etc by providing a serial port line.
LED indicators
1）Group 1 ~ 10 of LED indicator are on the left side of the front panel.
When a regular port connect with 1000 Mbps device, corresponding to the LED indicator light is green
normally on. When data transmission the indicator is flashing.
When the port work in 100Mbps or 1000Mbps full-duplex state, corresponding to the LED indicator light is
green on.
2）Power indicator
Its location on the left side of panel, when the switch's power is connected, this indicator light is green on. If
the light is out, check whether connect the power supply.
3）SYS indicator（system indicator）
。Its location on the left side of panel. When the switch has normal boot ,this indicator light is green on.
When the switch is power on self test, the indicator light is flashing. Check the switch losing power if the
indicator light is not bright.

The rear panel

The rear pane of switch with a dc power supply interface, an external power supply interface and a Reset
button. Working voltage range: 9-15 VDC
1） Dc power supply interface（Picture 3-3 the right side）
This is a DC power supply socket, plug the DC adapter into the socket, the power wire plug from the socket,
and the other side from the ac power
2）The external power supply interface（Picture 3-3 middle）
It can be external to the 12 v battery redundant power supplies
3）The Reset button（Picture 3-3 the left side）
Remove the switch Settings and restore the factory Settings
Picture 3-3 The rear panel of SW-GE1008F
8