Bosch GOS 10,8 V-LI Original Instructions Manual page 15

OBJ_BUCH-1311-002.book Page 15 Monday, February 28, 2011 9:32 AM
Note: The magnet 15 and the hook 16 are only
suitable for moving and removing loose, small
and light objects. Applying too much tension
can damage the inspection camera or the auxil-
iary aid.
Connecting the External Image Repro-
duction (see figure C)
The image signal of the inspection camera can
be transferred to an external monitor, which can
represent a standard NTSC video signal.
Insert the black plug of the supplied video cable
19 into the video output socket 18 of the inspec-
tion camera. Connect the video cable to an
appropriate monitor.
Read and observe the and operating instructions
of the external monitor.
Operation
Protect the hand unit 1 and the battery 10
against moisture and direct sunlight. Camera
cable, camera head and extension are water-
tight to a depth of approx. 10 m. However, the
hand unit and the battery are not protected
against water; in case of contact with water,
the risk of electric shock or damage is given.
Do not subject the inspection camera to ex-
treme temperatures or variations in tem-
perature. As an example, do not leave it in
vehicles for longer periods. In case of large
variations in temperature, allow the inspec-
tion camera to adjust to the ambient temper-
ature before putting it into operation.
Do not use the inspection camera when the
lens on the camera head 7 is misty or
fogged-up. Do not switch the inspection
camera on until after the moisture has evap-
orated. Otherwise, the inspection camera
can become damaged.
Bosch Power Tools
Initial Operation
Inserting the Battery
Use only original Bosch lithium-ion batteries
with the voltage listed on the nameplate of
your inspection camera. Using other batter-
ies can lead to injuries and pose a fire hazard.
Note: Using batteries not suitable for your in-
spection camera can lead to malfunctions or
damage the inspection camera.
Insert the charged battery 10 into the handle un-
til it can be felt to engage and faces flush against
the handle.
Switching On and Off
To switch on the inspection camera, press the
On/Off button 3. The display 5 shows the image
of the camera head 7.
To switch off the inspection camera, press the
On/Off button 3 again.
When no button on the inspection camera is
pressed for approx. 20 minutes, it automatically
switches off to save the batteries.
Regulating the Illumination Light in the
Camera Head
To brighten the camera image on display 5, the
illumination light 9 in the camera head can be
switched on and its brightness can be regulated.
To switch on the camera's illumination light 9
and increase its brightness, press button "+" 2
until the desired brightness is reached.
Do not stare into the illumination light 9 and
do not direct it at other persons. The bright-
ness of the light can blind the eyes.
To reduce the brightness and switch off the cam-
era light 9, press button "–" 4 until the desired
brightness is reached or the light is switched off.
Working Advice
Check the area that you want to inspect and pay
particular attention to obstructions or hazard
areas.
Bend the camera cable 6 in such a manner that
the camera head can be easily inserted into the
area subject to the inspection. Carefully guide
the camera cable in.
1 609 929 X35 | (28.2.11)
English | 15