Mt#3 Collets - Grizzly G8689 Owner's Manual

MT#3 Collets

The Model G8689 features an MT#3 spindle
taper, which only accepts MT#3 collets. MT#3
collets come in many sizes, typically ranging from
⁄ " to ⁄ " and 2mm to 20mm. You will need a
1 7
16 8
collet to match the diameter of the shank of the
tool you want to hold.
To install the MT#3 collet:
1.
DISCONNECT MILL FROM POWER!
2.
Remove the drawbar cap.
3. Carefully clean the surface of the collet and
spindle taper. Ensure that it is free of debris
and grease of any kind.
4.
Insert the cutting tool into the collet.
5.
Insert the collet up into the spindle taper.
6.
Slide the collet the rest of the way in until it
makes contact with the threads at the end of
the drawbar.
7. Using your fingers, thread the drawbar in
the collet until the collet draws up into the
spindle taper.
8.
While supporting the tool in the collet with
one hand, tighten the drawbar with the
17mm wrench in your opposite hand.
Note: Do not overtighten the drawbar.
Overtightening makes collet removal difficult
and causes damage to the drawbar threads,
collet, and the spindle taper. Keep in mind the
taper keeps the collet and tool in place. The
drawbar simply aids in seating the taper.
NOTICE
DO NOT completely unscrew the drawbar
before striking it with the hammer. You will
damage the threads on the drawbar and the
arbor.
-22-
Figure 17. Collet removal.
To remove the collet:
1.
DISCONNECT MILL FROM POWER!
2.
Tighten the column locks then insert the
spindle locking pin into the hole on the side
of the head.
3. Protect the table surface with a piece of
cardboard or hold the cutter or tool with a
shop towel to prevent it from falling out of the
collet.
4. Using the 17mm wrench, loosen the drawbar
but DO NOT remove it.
5.
Using the brass hammer, tap the drawbar to
unseat the taper (see Figure 17).
6.
Unscrew the rest of the drawbar by hand and
remove the collet.
Note: When not in use, always remove
collets and cutting tools from the spindle
taper. Oxidation may cause the collet to seize
and make it hard to remove later.
LACERATION
Leading edges of end mills
and other cutting tools can
be very sharp. Mishandling
can
Protect your hands with
glove or shop towel.
G8689 Mini Mill (Mfg. 8/06+)
HAZARD!
cause lacerations.