Appendix; Message List - Sony EVI-HD7V Operating Instructions Manual

Appendix

B

Message List

The following messages and indications may appear for this camera. Perform the following as
necessary.
Lamp display
Lamp
The STANDBY lamp and
POWER lamp flash slowly
in alternation.
The STANDBY lamp and
POWER lamp are lit.
Screen display
Message
CAUTION COOLING
FAN STOPPED!
(appears immediately after
startup)
PRESET n:OK
("n" is a preset position
number between 1 and 6)
RECALL n:OK
("n" is a recall position
number between 1 and 6)
RESET n:OK
("n" is a reset position
number between 1 and 6)
One Push WB:OP
One Push WB:OK
One Push WB:NG
78
Message List
Meaning and solution
Operating the camera in this state may result in malfunction. In this
case, "COOLING FAN:NG" appears on PAGE4 of the STATUS
menu. Turn off the camera, and consult your Sony dealer.
The SYSTEM SELECT switch is set to "no output" (page 55).
Meaning and solution
Operating the camera in this state may result in malfunction. Turn
off the camera, and consult your Sony dealer.
This message appears for about 3 seconds when you store camera
settings to POSITION 1 to 6.
This message appears for about 3 seconds when you recall camera
settings stored in POSITION 1 to 6.
This message appears for about 3 seconds when you reset camera
settings stored in POSITION 1 to 6.
During the white balance adjustment in the ONE PUSH white
balance mode, this message blinks on the screen.
When the white balance adjustment has been done correctly in the
ONE PUSH white balance mode, this message is lit on the screen.
When the white balance adjustment has failed in the ONE PUSH
white balance mode, this message blinks on the screen.