Sony EVI-HD7V Operating Instructions Manual page 55

Rear
E DC IN 12 V connector
Connect the supplied AC power adaptor.
F SYSTEM SELECT switch
Used for selecting the video format of
the signal to be output from the VIDEO
OUT connectors.
For details, see "Setting of the SYSTEM
SELECT switch" (page 55).
G IR SELECT switch
Select the camera number when you
operate multiple cameras with the same
remote commander.
H VISCA IN connector
Connect to a computer via an RS-232C
interface. When you connect multiple
cameras, connect it to the VISCA OUT
connector of the previous camera in the
daisy chain connection.
I VISCA OUT connector
When you connect multiple cameras,
connect it to the VISCA IN connector of
the next camera in the daisy chain
connection.
J VIDEO OUT connector
Supplies the images as an analog
component signal. Digital signals are
also output from this connector.
Bottom
K BOTTOM switches
Used for RS-232C baud rate selection,
turning the remote control signal output
on/off, and selecting whether to add
sync.
For details, see "Setting of the
BOTTOM switches" (page 57).
L Tripod screw holes (1/4-20UNC)
When you install the camera to a tripod,
secure the tripod to these screw holes.
M Fixing screw holes (M3)
Used for fixing the camera to a fitting
using M3 screws.
Setting of the SYSTEM SELECT
switch
This switch allows you to select the video
format of the signal to be output from the
VIDEO OUT connectors.
Notes
• Be sure to set this switch before you turn
on the power of the camera. You can also
set this switch in the standby mode of the
camera. After completing the setting, turn
on the power of the camera by connecting
it to an AC outlet using the supplied AC
power adaptor and AC power cord, or by
using the VISCA command. When you set
this switch in the standby mode, press the
POWER switch of the remote commander.
This switch setting becomes effective.
Location and Functions of Parts and Controls
55