Memory Configurations - HP Compaq 8300 Elite Quickspecs

Hide thumbs Also See for Compaq 8300 Elite:

Maintenance & service manual (195 pages)

Reference manual (179 pages)

Specification (81 pages)

Table of Contents

QuickSpecs

Technical Specifications – Memory

System Memory Support

The HP Compaq Elite 8300 Business PC supports the 2nd and 3rd generation Intel® Core™ processor families. Based on a

new PC micro-architecture, the processor is designed for a two-chip platform consisting of a processor and Platform

Controller Hub (PCH). Unlike previous generations, the processor includes an integrated memory controller (IMC). The IMC

supports DDR3 protocols with two independent, 64-bit wide channels each accessing one or two DIMMs.

Two channels of non-ECC DDR3 unbuffered dual in-line memory modules (UDIMM) or DDR3 unbuffered small outline

dual in-line memory modules (SO-DIMM) with a maximum of two DIMMs per channel

Single-channel and dual-channel memory organization modes

Data burst length of eight for all memory organization modes

DDR3 memory data transfer rates of up to 1600 MT/s; actual supported DDR3 data transfer rate determined by the

configured processor.

64-bit wide channels

DDR3 system memory I/O voltage of 1.5V

Theoretical Maximum Memory Bandwidth:

10.6 GB/s in single-channel mode of 21.3 GB/s in dual-channel mode assuming DDR3 1333 MT/s

12.8 GB/s in single-channel mode or 25.6 GB/s in dual-channel mode assuming DDR3 1600 MT/s

32 GB maximum memory support depending upon available number of DIMM sockets

CAUTION: You must shut down the computer and disconnect the power cord before adding or removing memory modules.

Regardless of the power-on state, voltage is always supplied to the memory modules as long as the computer is plugged in

to an active AC outlet. Adding or removing memory modules while voltage is present may cause irreparable damage to the

memory modules or system board.