Replacing The Palm-Rest Assembly - Dell Inspiron N5110 Service Manual

1 power-button board cable
3 screws (4)
CAUTION: Carefully separate the palm rest from the computer base to avoid damage to the palm rest.
8. Using a plastic scribe, carefully pry out the palm-rest assembly along the rear edge and then ease the palm-rest assembly from the computer base
9. Lift the palm-rest assembly off the computer base.
1 plastic scribe
Replacing the Palm-Rest Assembly
1. Follow the instructions in Before You
2. Align the tabs on the palm rest assembly with the slots on the computer base and gently snap the palm rest assembly in place.
3. Slide the touch-pad cable, power-button board cable, and hot-key board cable into the connectors on the system board and press down on the
connector latches to secure them.
2 touch-pad cable
4 hot-key board cable
2 palm-rest assembly
Begin.