Display Assembly - Dell Inspiron N5110 Service Manual

Back to Contents Page
Display
Dell™ Inspiron™ N5110 Service Manual
Display Assembly
Display Bezel
Display Panel
Display Cable
Display-Panel Brackets
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at dell.com/regulatory_compliance.
CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell is
not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION: To help prevent damage to the system board, remove the main battery (see
computer.
Display Assembly
Removing the Display Assembly
1. Follow the instructions in Before You
2. Remove the battery (see Removing the
3. Remove the two screws that secure the display assembly to the computer base.
4. Follow the instructions from
5. Disconnect the display cable and touch-screen cable from the system-board connectors.
NOTE: The touch-screen board is optional and may not be present in your computer.
6. Disconnect the Mini-Card antenna cables from the connectors on the Mini-Card(s) (see
7. Note the routing of the Mini-Card antenna cables and remove the cables from the routing guides.
8. Remove the four screws that secure the display assembly to the computer base.
9. Lift the display assembly off the computer base.
Begin.
Battery).
step 3 to step 9 in Removing the Palm-Rest
Removing the Battery) before working inside the
Assembly.
Removing the Mini-Card(s)).