Table of Contents
Advertisement
OPERATE
ON
OFF
CHP
LIGHT
TEST
MENU
EXIT
ENTER
PRESET
HIDE
T
ZOOM
FOCUS
W
Indicator
RS232C
Rx
Tx
MENU
EXIT
Downloaded from ProjectorsManual.com Manuals
d
Adjusting focus
To focus on nearer points, press the [FOCUS +] button
f -
A
To focus on farther points, press the [FOCUS -] button
e
Hiding the image temporarily
Press the [HIDE] button
● The displayed image will disappear.
● Press the [HIDE] button again the restore the image.
e
d
f
Turning off the power
A
Press the [OPERATE OFF] button for 1 second or more
● The [OPERATE] indicator turns off, the [STAND BY] indicator starts
● This unit switches to the standby mode at the end of the cool down
OPERATE
ON
OPERATE
OFF
f -
A
HIDE
Indicators on this unit
e
d
B
Pull out the power plug from the power outlet
Precautions During Use
This unit makes use of a light source lamp that may reach a high
temperature during projection. Do not allow projection under the
following conditions. Doing so may cause fire or malfunction of
the unit.
● Projection with the unit laid on its sides
● Projection with the unit installed in an unreasonable angle
Avoid using this unit at an inclined angle. Doing so may cause
unevenness in the color or shorten the lamp life.
● Projection at a location that blocks the air inlets or exhaust vents
● Projection without removing the lens cap
TEMP
FAN
HIDE
Indicators on this unit
blinking and this unit switches to the cool down mode. The cool down
mode will last for about 60 seconds to allow the temperature of the
light source to cool off. (A Page 15)
mode.
STAND BY
OPERATE
LAMP
NOTE:
The [OPERATE OFF] button will not work within approximately 1
minute after the light source has been turned on. Start operation
only after 1 minute's time.
CAUTION:
Do not pull out the plug when the [STAND BY] indicator is blinking.
This may shorten the lamp life and cause a malfunction.
Light On
Blinking
Light off
27
Advertisement
Table of Contents
