Lab.gruppen PLM series Quick Start Manual page 30

Quick Start Tutorial
5. After ensuring that no audio is being output from the mixing console, power on the PLM.
6. On the Tablet PC, launch the Lake Controller software application. Select the appropriate network
adapter if more than one is enabled, and tap NO to the dialog asking whether to load the previous
configuration.
7. Tap MODULES to access the Module Menu and scroll bar.
8. On the Module scroll bar, the PLM is represented with a frame containing two discs. These are
labeled A and B and represent the two Lake processing modules.
9. Tap the frame to select it, then tap again in the MAIN area of the screen to place both modules of
the frame in the current system configuration. The Lake Controller uploads settings from the PLM.
10. Tap the icon for Module A; its border will turn yellow to confirm selection and an LED on the front
panel of the associated device will also be illuminated.
11. Tap the MODULE STORE/RECALL button on the Modules Menu; the menu will change to show
additional options.
12. Double-tap the Default Modules folder then double-tap the Contour Classic Crossovers folder. A set
of loudspeaker symbols will be displayed.
13. Tap CL3w+1a, and then tap the RECALL button. This configures the DSP for the Module A as a
3-way crossover, plus a separate auxiliary channel.
14. Tap YES when asked to confirm that all data will be overwritten; tap 2-Way on the subsequent dialog
regarding Module B configuration (not be used during this tutorial).
15. Tap STORE/RECALL EXIT to return to the Modules Menu.
16. Ensuring Module A is still selected (yellow border), tap I/O CONFIG.
17. The top-right of the I/O CONFIG screen displays a block diagram of Module A, including an input
gain mixer summary. Tap on the blue INPUT 1 block to open the Input Mixer.
18. The Input Mixer shows the individual input levels and connectivity status, along with a meter on the
right which displays the combined mixer output signal level. Verify Input 1 fader is set to 0.00 dB and
turn all other inputs off.
19. Tap the blue return arrow button at the bottom right of the screen to return to I/O CONFIG.
20. Locate the small square block labeled POST EQ towards the bottom of Module A's block diagram.
A setting of POST EQ indicates that the Auxiliary output channel is fed from same audio source and
the 3-way crossover.
24
PLM Series Quick Start and Field Reference Guide Rev 1.3.5