Change Engine Oil; Refueling; Air Cleaner - PowerWasher pwh2600 Instruction Manual

CAUTION:
Used oil is a hazardous waste product. Dispose of used oil properly. Do not
discard with household waste. We suggest you take used oil in a sealed container to your local
recycling center or service station for reclamation.

CHANGE ENGINE OIL

Drain the used oil while the engine is warm. Warm oil drains quickly and completely.
1. Place a suitable container below the engine to catch the used oil, and then remove the ller
cap/dipstick, the drain bolt and sealing washer.
2. Allow the used oil to drain completely, and then reinstall the drain bolt and sealing washer,
and tighten it securely.
3. With the engine in a level position, ll to the upper limit mark on the dipstick with the
recommended oil. See pages 6-7 for more details.
4. Reinstall the oil ller cap/dipstick securely.
Running the engine with a low oil level can cause engine damage.
OIL FILLER
CAP/DIPSTICK
SEALING WASHER
DRAIN BOLT

REFUELING

With the engine stopped, remove the fuel tank cap and check the fuel level. Re ll the tank if the
fuel level is low.
Refuel in a well-ventilated area before starting the engine. If the engine has been running, allow it
to cool. Refuel carefully to avoid spilling fuel. Do not ll above the fuel strainer shoulder. After
refueling, tighten the fuel tank cap securely.
Never refuel the engine inside a building where gasoline fumes may reach ames or sparks.
Keep gasoline away from appliance pilot lights, barbecues, electric appliances, power tools, etc.
Spilled fuel isn't only a re hazard, it causes environmental damage. Wipe up spills immediately.
CAUTION:
Fuel can damage paint and plastic. Be careful not to spill fuel when filling
your fuel tank. Damage caused by spilled fuel is not covered under warranty.

AIR CLEANER

Remove the air cleaner cover and inspect the lter. Clean or replace dirty lter elements. Always
replace damaged lter elements. If equipped with an oil-bath air cleaner, also check the oil level.
28