Montarbo E616A Instruction Manual page 51

NUMBER CONFIG. (LED)
1 P1
2 P2
3 P3
4 P4
5 P1 + Sub1
6 P1 + Sub2
7 P2 + Sub1
8 P2 + Sub2
9 P3 + Sub1
10 P3 + Sub2
11 P4 + Sub1
12 P4 + Sub2
0 P0 + ..........
The following table has a description of the four factory presets.
In the first 4 presets (number 1 to 4) the SUB OUT output is disabled.
DESCRIPTION
NATURAL FLAT
LOUDNESS
LONG THROW
FRONTFILL FLAT
NATURAL FLAT + wide range subwoofer output (TANK series subwoofer)
NATURAL FLAT + band-limited subwoofer output (BX series subwoofer)
LOUDNESS + wide range subwoofer output (TANK series subwoofer)
LOUDNESS + band-limited subwoofer output (BX series subwoofer)
LONG THROW + wide range subwoofer output (TANK series subwoofer)
LONG THROW + band-limited subwoofer output (BX series subwoofer)
FRONTFILL FLAT + wide range subwoofer output (TANK series subwoofer)
FRONTFILL FLAT + band-limited subwoofer output (BX series subwoofer)
USER PRESET = one of the above after being personalized by the PC program
Presets [+ Sub1] are suitable for connection with subwoofers of the TANK
series, that must be adjusted as follows (one subwoofer for each satellite):
slope = 12 dB / oct
phase = 0 deg
Volume = center
Refer to relative TANK manual.
Presets [+ Sub2] are suitable for connection to sub BX181A and/or BX152A,
that must be adjusted as follows (one/ two subwoofer every two sub
satellites):
phase = 0 deg
Volume = center
Refer to relative BX manual.
When you select one of the base presets (no sub) on the sub output is still
present a not filtered signal, but it is alligned to the satellite; this signal can
be used with any other type of subwoofer and/or speaker to which you do
not want to send a filtered signal.
The UP and DOWN push-buttons make it possible to select the desired
preset.
Push the UP button and the preset number increases; pushing the DOWN
button and the preset number decreases.
The selected preset's LED will flash, but the new preset is not yet active.
To make it the active preset, push both the UP and DOWN buttons at the
same time. The new preset will be active after a few second delay.
Two LEDs will come on: both P0 and the one related to the preset which
has been modified to create P0.
During the presets loading phase, the system is muted.
51
ENGLISH